Order Online Or Call 
Product LocatorThe SANYO PLC-SW35 projector lamp
Written by Samantha Friday, 05 February 2010 09:27
The Sanyo PLC-SW35 projector lamp is the genuine replacement projector lamp for the Sanyo PLC-XE31 projector.
The Sanyo PLC-SW35 projector lamp has an average lamp life of 2000 hours and a wattage of 160. It is a UHP lamp (ultra high performance).
There are a few ways you should note that make it possible to ensure your Sanyo PLC-SW35 projector lamp will give you the best value for money.
The projector lamp will come with instructions on maintenance and installation, which you should read before you begin to install the replacement lamp.
It is crucial that you ensure the Sanyo PLC-SW35 projector lamp is handled as little as possible because this will impact on the lamp life and could even severely damage the projector lamp.
Never move your projector whilst it is in use. Not only is this damaging for your projector but it could actually completely shatter your Sanyo PLC-SW35 projector lamp beyond repair. Equally, if you do need to replace the Sanyo PLC-SW35 projector lamp do not attempt to do this until the entire projector unit has cooled down after it has been used.
Always keep the air ducts on your projector cleaned and clear of dust and equally as important is that you should never have any of these air vents covered whilst the projector is in use because this will cause overheating and will damage your projector lamp.
At JP UK we are primary UK suppliers to educational establishments, churches and businesses throughout the UK. We supply every projector lamp available from the Sanyo PLC-SW35 projector lamp to projector lamps that are required for discontinued projector units.
